This post contains affiliate links to products. The clicking sound is played through the speaker in your car; in some cars, the turn signal shares the same speaker as the radio. I haven't been inside my door where the speakers are yet, but their is a white, plastic water seal that is stuck to the inside of the door with some sticky putty. 6 posts • Page 1 of 1.
I'm going to try some 1/16" silicone gasket material. If it does please let me know and show a pic. If you're wondering why are the turn signals not working, you'll find the answer in this section. Wait for 1 hour after spraying properly and let dry. Turn signal and car radio share the same speaker. Speakers in and out. In a non-amplified vehicle, chimes, turn signals and onstar come through the external speaker. A car's fuses are a safety mechanism to protect all electrical components from being damaged. My radio and turn signal sound not working on my computer. Amplifier connection. There are plenty of signs that the battery or alternator is weak or dying: - The starter making a dragging and/or rapid clicking noise when you turn the key. Problem 4: Damaged Speaker. It goes in because there is no seal in between the upper and lower seal. Local GM dealer quoted me, "At least $1200. Depending on your car's issue, it may be caused by the named causes.
My rears are always soaked. Remove the old relay. Blown fuses in the car's electrical components are the easiest problem to fix. Maestro RR with default firmware options when flashed, flashed 12/2/2018. Plenty of Silverado owners have experienced the same issue. Use a fuse puller or your fingers to remove the turn signal fuse. Also when I turned the car on after I did that my service airbag light came on. Turn signals - No clicking noise. How to Troubleshoot If My Radio and Turn Signal Sound Not Working. This is where my water enters my doors. If neither of the lights is working and there's no issue with the bulb or bulb sockets, you most likely have a damaged flasher module. Same problem, no sound. We'll also discuss some common reasons why the turn signal lights don't work. This morning I turned off Joe mode as well. If you find any issues, repair or replace the affected wires as necessary.
So you're talking where the door contours and there isn't a seal then? If there is a voltage of 3 volts all the way to 12 volts, then something is staying on while the key is off. In this situation, there's enough voltage for the truck to start and run, but the voltage isn't high enough for the radio to work. 00 each from GM in Detroit.
Find the radio fuse in the passenger side dash fuse panel. My I tensions were to trouble shoot the amp maybe replace it but when I looked under the dash there wasnt one there. I checked OnStar last night (which I have never used), and it is playing through the receiver as expected. Identifying the possible causes is essential to have adequate measures and solutions that prevent the same from happening in the future. This can short out the amp and flood the carpet (This one can also come from a clogged A/C condenser drain so check that too). My radio and turn signal sound not working on computer. In some cases, a broken wire or bad connection in the speaker wires where they pass through into a door can also cut off the sound altogether rather than just cutting off the sound to one speaker. If one of the turn signal lights works properly and the other doesn't, it's a good sign that you're dealing with a worn-out bulb. I have no sound, from the radio, the turn signals, the door chimes or the lights left on sounds. So, first, you need to troubleshoot. If swapping the relay solves the problem, that means a bad relay was the main reason behind the turn signal not clicking. Depending on where your amp is located, it may be easy or quite difficult to check the amp. It allows water to run down into that gap and soak the speaker wire connection.
Faulty indicator relay. The car still did not play any audio sound cues for the turn signals and the volume for my music was playing very faintly. If I can get them to stick and cover one another it make work and still give service access if needed.