Your Uniflame® Electric Heater uses infrared rays to warm objects directly. If your gas fire pit lights but doesn't stay lit, this can also be a result of dirty ports or faulty valves. When you turn off the fire pit, let it cool down properly. Another reason the supply of gas could be interrupted is if there is air in the gas line. If the pilot lights, but in turning knob to the "ON" position the unit goes out, then this is caused by a blockage in the pilot. If there is no spark, your fuel won't light up. Before you start your chimney, you'll want to get it inspected.
The thermopile can be tested with a multimeter where it analyzes the TH/TP contacts to determine how much electricity is being produced. You can try running gas through the line to get rid of the air. How Does an HPC Ignition Work? While both parts are similar in the fact that they help convert deliver gas to the fireplace and convert heat into electricity, the thermopile does generate more of an electrical current in comparison. The UniFlame® Electric Heaters are designed for outdoor use only. Your fire pit will not stay lit if there is something blocking the flame. Using a standard grill gas tank, your outdoor fireplace will burn for approximately 10 hours when on the high flame setting. Most of our products are made from non-stainless steel. As you might imagine, any kind of damage or defects here will cause an uneven flame. This smart device constantly weighs the tank, allowing you to track and monitor gas levels with a smartphone app. If the alignment is not correct you could have a problem securing the fitting.
From eyeglasses, to office chairs, cherished childhood stuffed animals, and trinkets and toys. Alternatively, you might wish to utilize a bigger-size regulator on the gas line to prevent too much gas from coming out and creating a sound similar to this "whistling. Here's the thing, not all the wood needs to be the same width. If the fittings have bubbles, tighten them well. Use a full cylinder. If you have the skill and the inclination, we suggest you DIY a propane fire pit. One of the most common reasons why a wood fire pit might refuse to stay lit is if the wood is too thick. Remove the lava rocks or fire glasses from the propane fire pit.
This is why it's recommended that you only use dry firewood — classified as a moisture content of 20% or less — in your fire pit. Oxygen Depletion System. You'll locate the main gas control valve, then the thermopile sensor which should have its electric contacts labeled (TH/TP and TP) on the valve itself. Since gas fire pits are hooked up directly to the main gas line, any kind of kinks will cause problems. Drip Loop: moisture in the gas line can cause a failure in the drip loop. If you are lucky, you may not have to change any parts of your fire pit. Turn cylinder valve "OFF" and replace cylinder. If the gas pressure is too high or too low, then it will cause performance issues. If fuel levels are low, get the tank refilled. This will guarantee that the fire burns uniformly and prevent fires and explosions from occurring. Step 3- Connect with the Hose. Remember to not turn the gas up all the way – this will cause a large flame to immediately burn and is also very dangerous. Note that the combustion requirement is specific to table top patio heaters manufactured on or after the effective date of the requirement. Turn off the gas supply.
If you're unsure, don't proceed. To work on your fire pit, turn off the gas. Low flame in a propane gas fire pit can be because of a few reasons. Your product is designed to pull air up through the chimney. Is the gas valve completely open, on, and rotated left all the way? The standard circuit has a capacity of 15 amps. Alternatively, you can arrange your firewood in log cabin stacks. If you have enough experience dealing with propane tanks, you can estimate fuel levels by a tank's weight. To ignite the fire, you would use a long-stem lighter or a long match near the burner. You can also choose any parts from any company that matches your fire pit. When running at full capacity, your UniFlame® Electric Heater will product draw between 12 and 14 amps. Look for any awkward bends or tight squeezes in your supply line.
Pilot Light Problems. If log placement is not specified in the manual, you can place the logs how you like. The thermocouple signals the gas valve to stay open when the pilot lights are on. To prevent this problem from happening, cover your fire pit after use. Never Connect two (2) or more extension cords together. So, turn the valve clockwise and secure it. This is a good time to go ahead and check your valves and thermocouples as well. Consumer Guarantees Act | Consumer Protection.. Retrieved November 9, 2021, from Quick and Easy 5 minute Appliance Fixes.
You can fix this by running gas through the hose. To ensure functionality and to optimize the flame display, it is good practice to regularly clean and properly store your fire pit. It might be hard to start and it might go out. One of our most popular offerings is the electronic fire pit ignitions from HPC Fire. Full warranty details can be found in your owner's manual. Gas pressure may be low. The control valve has been damaged. You slip the hook through the handle of the tank, lift, and read the remaining gas levels on the gauge. When you install the tank, remove the plastic seal or cap of the gas tank. Electronic Ignition – Troubleshooting. TriNova Grill Cleaner Spray for BBQ. You can also use damp cloths to wipe off grease and oil from the fire pit. Absolutely, our wood burning outdoor fireplaces are designed for normal wood logs, and manufactured wood logs (i. e. Duraflame® logs). It's all about generating heat in the center, having lighter material catch fire first, and then letting it all fall into the center as it burns.
Nonetheless, if you are not at peace with the gas source and prefer something more eco-sustainable, explore electric or bioethanol fire pits as an alternative. For best results, please perform routine maintenance on your product – see manual for cleaning instructions, and use a high quality cover if storing the unit outside. HPC Fire Pit Kit Warranty. The hose also comes with a universal fit that works with most US-standard 20-pound propane tanks and LP regulators. Or connect with us on social media and let us know. Stainless steel pan, valve box: Commercial - 1 year; Residential - 5 years. But with wood fire fits, the 'fuel' is the wood itself. Gas leaks can be very dangerous. A fire pit with an electronic ignition kit requires power to operate and can be used with a switch or a remote.
You can change the propane fire tank by yourself with no problem. The thermopile opens up this gas valve when the fireplace is switched on. They're built to exacting standards, but like all things they are subject to wear and tear over the years, so we've put together this guide to help you diagnose and repair your HPC electronic ignition. There may be an indication of a gas leak if insects—which are attracted to the smell of gas—are nestling inside the ports. If it reads less, then the thermopile should be cleaned (turn off the gas supply and use a stainless-steel brush with fine-grit sandpaper), if the reading is still low, then replace the thermopile. You can find the model number, serial number, and gas type on the side of the valve box underneath the burner and pan. Make sure that there are no open flames near the gas because this could cause an explosion. The propane tank is empty. If you do see some red rust it is probably due to some iron particles that have contaminated the surface of the stainless steel and it is these iron particles that are rusting. Under the same conditions the maximum carbon monoxide (CO) level shall at no time exceed 100 ppm (parts per million). Please do not return the product to the store.
The flame itself should be touching the sensors that surround it.