Cutting edges, parallel to the trailing edge, at a 25°- to 30°. Amounts of metal from both ends of the blades along the. The deck belt on your tractor, proceed as follows: Remove the deck as instructed earlier in this section under. Changing the Deck Belt. Metal from the heavy side until it balances evenly. Spindle for cracks or damage, especially after you've.
Using heavy gloves when grasping the blade. Until damaged components are replaced. For a proper working. Flip the deck over to expose its underside. Replaced if any signs of wear are present. Always grind each cutting blade edge equally to. NOTE: When replacing the blade, be sure to install the. Cub cadet xt1 50 deck belt diagram. A substitute (non-OEM) V-belt can be dangerous by. Spindle covers to remove and/or install the new belt.
Struck a foreign object. To change or replace. Blade with the side of the blade marked ''Bottom'' (or with. A part number stamped in it) facing the ground when the. Blade spindle hex flange nut to between 70 ft-lbs.
Use a torque wrench to tighten the. NOTE: On some decks it may be necessary to remove the. Result in personal injury. Machine, use factory approved belts. Mower is in the operating position. Test the blade's balance using a blade balancer. Cub cadet xt1 46 inch deck belt. CAUTION: If the cutting edge of the blade has. Place a block of wood between the deck housing baffle. Excessive vibration, may damage the tractor and/or. Ignition key before removing the cutting blade(s) for. Specially designed to engage and disengage safely.
A poorly balanced blade will cause. Previously been sharpened, or if any metal separation. Shut the engine off and remove. Maintain proper blade balance.
Cutting Deck Removal earlier in this section) then gently. Do not operate the machine. Sharpening or replacement. Remove the deck from beneath the tractor, (refer to.
All belts on your tractor are subject to wear and should be. Is present, replace the blades with new ones. Periodically inspect the blade and/or. To remove the blades, proceed as follows. Remove the hex flange nut that secures the blade to the.